Week 76  This week we get more brass bulkheads

The bits we received

And what we did with them

The first few bits of brass went in place very easily.

These next two bulkheads needed a bit of fettling to get them to fit properly.

Those scratches adjust where I scraped some excess glue off.  They look much worse than they really are !

A couple of ladders to go on.  The bottoms needed trimming as they were a little too long.

Things not yet done

Week 9 : Fit rudder servo tray
Week 18 : Fit the fore deck
Weeks 37 & 38 : Fit the bilge keels
Week 42 : Plank the porthole areas
Week 43 : Fit the resin bow piece
Week 47 : Fit sea chest grills
Week 54 : Drill the portholes
Week 65 : Done
Week 67 : Fit Anti aircraft bridge
Week 71 : Modify wind speed and direction indicators
Week 72 : Fit remaining bulkhead : Done
Week 73 : Fit part 573
Week 75 : Fit part 633

Hot tip of the week

If you're after a superb finish, remove all excess glue and fill all the little gaps between the brass builkheads

How many hours does it take to build the model ??

This week :

4 hrs

Running total :

hrs

Take me back to week 75

Take me to week 77