Week 44  This week more plastic bulkheads

The bits we received

And what we did with them

These parts went in quite easily.  I used slow setting Araldite as before.  Just do plenty of test fitting to make sure they are a good fit. I did need to trim an odd bit here and there to get a perfect fit.

Here are the parts glued in place, and you can see where I sanded down the edges to get a flat surface for the etched bulkheads that will eventually go here.

A close up of the forward part.

And a close up of the rear part.

Things not yet done

Fitting the fore deck
Stern deck part 63 not fitted.
Fixing deck
Fitting resin stern part 70
Fitting resin propshaft part D
Fit the bilge keels
Fit the resin bow

Hot tip of the week

Make sure parts fit correctly with lots of test fitting before gluing.

How many hours does it take to build the model ??

This week :

3 hrs

Running total :

181 hrs

Take me back to week 43

Take me to week 45